Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX command to show tunnel status up or down

I would like to ask if there is a specific command within the PIX OS that will allow me to show if the tunnels that I have set up for VPN from a remote PIX to the local one are active...

I have looked throught the show ? on the Pix but cannot determine...

You would think there would be a "show tunnel" command...

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PIX command to show tunnel status up or down

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

4 REPLIES
New Member

Re: PIX command to show tunnel status up or down

show isakmp sa

This will show you all your vpn connections.

New Member

Re: PIX command to show tunnel status up or down

Thank You!

Cisco Employee

Re: PIX command to show tunnel status up or down

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

New Member

Re: PIX command to show tunnel status up or down

Thanks Arul!

3494
Views
0
Helpful
4
Replies