Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX config for multi internal IPs

Hi,

I am trying to set up a PIX 501, and would like to have separate IPs for the inside interfaces. Is there a way to assign an IP to each port? or is this something that requires 2 inside interfaces? What I am trying to do is to segment the network at the PIX, like vlans.

Thanks

  • Other Security Subjects
4 REPLIES
New Member

Re: PIX config for multi internal IPs

If you're asking if the 501 supports a DMZ interface, the answer would be no. You cannot assign each inside port an IP address.

New Member

Re: PIX config for multi internal IPs

I am trying to set up two separate networks segments and thought that we could use the PIX since we already have it. I wanted to try and do this without buying a switch. Do any of the PIX products allow more then 1 inside interface?

Thanks - Wayne

New Member

Re: PIX config for multi internal IPs

PIX 515, 525 and 535 support DMZ interfaces. Unfortunately the 506 and the 501 do not. A solution may be to use a small router to create two segments, then you can continue to use the 501.

New Member

Re: PIX config for multi internal IPs

Thanks

96
Views
0
Helpful
4
Replies