Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX config restoration

I have my existing PIX config with all the access-rules and ......Backing up to tftp server as well.I had write erase my PIX.How should I restored back my config from my tftp to the PIX after I had write erase.

pls advise

1 REPLY
Gold

Re: PIX config restoration

The following post is from another post by L Mourits - A good explanation,

The command syntax is:

configure net [[location]:[filename]]

(from enable mode ofcourse)

Let´s say you want to load a config from tftp server with IP address 10.1.1.1 and file is named pix-conf the command would be:

configure net 10.1.1.1:pix-conf

you could also just enter "configure net" to start the wizard and answer the questions

Remember that the loaded config is merged into any existing configuration, so, best practice would be to first execute the "write erase" command and then the "configure net"

Hope this helps --

92
Views
0
Helpful
1
Replies
CreatePlease login to create content