I have PIX running version 7.1(2). I use "nat 0" for all outbound traffic to bypass NAT. I have 5 different networks bypassing the PIX NAT. But I would like to apply NAT just for a new network without affecting other traffic. I want this new network to be translated to a specific routable IP.
is this a possible solution? I am trying to aplly NAT on only 10.1.1.0 255.255.255.0 network.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...