Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side.We apologize for the inconvenience it may have caused.
New Member

pix connecting to modem/router

My network need additional security. I replaced the previous firewall with the PIX 515E. Connecting it to the (DLINK DSL-G604T)router, there is no communication. How can i solve the problem

1 ACCEPTED SOLUTION

Accepted Solutions

Re: pix connecting to modem/router

What level of comunication issue you have? Is it due to cabling issue (straight vs cross-over UTP) or configuration?

Make sure you use cross-over utp. If this is already in place, make sure both router and pix interface is in unshut/active mode. Other than that, check the IP asigned for the router and PIX interfaces + netmask. Other than that, maybe you need to allow icmp from router to reach pix outside interface (or any interface you connect to router).

On the PIX end, is the LED blinking/on when you connect to the DLINK router?

Rgds,

AK

2 REPLIES

Re: pix connecting to modem/router

What level of comunication issue you have? Is it due to cabling issue (straight vs cross-over UTP) or configuration?

Make sure you use cross-over utp. If this is already in place, make sure both router and pix interface is in unshut/active mode. Other than that, check the IP asigned for the router and PIX interfaces + netmask. Other than that, maybe you need to allow icmp from router to reach pix outside interface (or any interface you connect to router).

On the PIX end, is the LED blinking/on when you connect to the DLINK router?

Rgds,

AK

New Member

Re: pix connecting to modem/router

Thanks for the tips . i failed to turn on the interface

96
Views
0
Helpful
2
Replies
CreatePlease to create content