Does any body have an idea how to connect up a PIX with two ISP connections and setting up two default gateways. Of course without involving an external router. For example, if I have a PIX with 4 NICS and have two Ethernet feeds from two providers, how can I set one as an backup default gateway, in cae the primary fails? ( One ISP goes to 'outside; and the second ISP goes to say 'dmz3')
I know this is not normally done in a real situation. I'm just curious.
The only way to pull something like this off, would be to know exactly where you need to send the traffic. So in this case it wouldn't really be another default gateway but rather just a static route..
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...