Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

PIX disconnection

HI all,

I have PIX 506E as ainternet gaetway for my ISP and suddenly after successfull running of 2hr internet disconnected and then automatically connects.

And sometimes the bandwitch rate become slow .

Is their any kind way where i can check what is going from pix inside to outside and whts coming from outside to inside

Thanks

Chetan

  • Other Security Subjects
5 REPLIES
Bronze

Re: PIX disconnection

Hi

the only thing you can check is "sh conn". it will show you IP address and port information of traffic coming in and out.

regards

aashish C

New Member

Re: PIX disconnection

Thanks

Is there any way to capture all the interfaces incoming and outging traffic

Bronze

Re: PIX disconnection

incase you want detailed reporting of the traffic going out and coming in the PIX, then you need to configure Accounting on PIX. Here is the URL which will help you in configuring it on PIX :

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/ab.htm#wp1073208

regards

aashish C

Gold

Re: PIX disconnection

PIX has great feature for capturing packets

try command capture

Details are here:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a6.html#wp1053548

M.

Hope that helps, rate if it does

Re: PIX disconnection

Hello,

does your outside interface get a DHCP-assigned address from your provider ? If this happens every 2 hours, it might be that your provider has a very low lease time. Have you contacted the provider (which could be useful anyway, to see if they can see problems on their equipment/lines) ?

Regards,

GNT

96
Views
0
Helpful
5
Replies