Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX displays weird ASCII Characters on boot

I have a PIX 515 that displays one line of odd ASCII characters at boot then the PIX does nothing after that (does not respond). Tried to change console settings but to no avail. Any ideas?

1 REPLY
Silver

Re: PIX displays weird ASCII Characters on boot

Ensure that your display is set for the "US-ASCII" character set.

Also when the failover only pix boots up, if it does not detect a primary at the other end of the failover cable, it will stop functioning. Please check the failover cable.

147
Views
0
Helpful
1
Replies
CreatePlease to create content