Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX DMZ ports up &down

on my two DMZ i am setting up. the line is up but the protocol is down. I can not figure out how to get it up. This is a new setup. one is staight to a server and the other to 6509 switch. Any help would be very nice. My head is going to go boom.

Jason

1 REPLY
New Member

Re: PIX DMZ ports up &down

I suppose your protocol isn't administratively down (by you) then you have a mismatch between the PIX's Ethernet config and the Ethernet network. Then look at the physical layer first, example try to connect a PC instead of PIX to the network and look what's about. Then if physical seems ok, look for Ethernet speed and duplex mode if it match in the PIX config.

Benoit

85
Views
0
Helpful
1
Replies
CreatePlease to create content