PIX Downgrade from v701

[r.perera]

Hi, I know this is nor right, I upgrade to v701 with 32MB memory, and now PIX is in a rebooting loop.

I can get to monitor mode, any one know the downgrade from monitor mode. Or how could I get out of the loop. If I get to command line I can downgrade

Best regards

RP

[ohanusi]

in the monitor mode

type the question mark , you see all the command.

see the below.

eg

file pix634.bin

gateway 172.16.1.1

interface 1 ( ethernet 1)

gateway 172.16.1.5 (if the tftp is on a diffent network)

address 172.16.1.2 ( temporary address for the pix)

server 172.16.1.10

ping 172.16.1.10 (confirm the server is reachable)

The finally

tftp to do the download

monitor> ?

? this help message

address [addr] set IP address of the PIX interface on which

the TFTP server resides

file [name] set boot file name

gateway [addr] set IP gateway

help this help message

interface [num] select TFTP interface

ping send ICMP echo

reload halt and reload system

server [addr] set server IP address

tftp TFTP download

timeout TFTP timeout

trace toggle packet tracing

[r.perera]

Hi, Thanks for the update,

I thought about it and was reluctant to go that way cos, there is a downgrade special command in the commnad line.

But, this time I had to make up my mind and just did it, yes it works but it ask for activation key

Thnaks again

[ohanusi · Accepted solution]

register the pix on the cisco site as if you are upgrading the license to 3 des. (use the serial number from show version)

They will send you the activation key. (hope you have a cco account)

Then use the activation key comman to enter the key.

If you remember the former key when the pix was running 6.3(x), you can enter this .