Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX Failover configuration?

I need clarification on the pix failover.

Each PIX will have it's own inside and outside ip addresses. You can't use the same ip on both units (correct?).

We currently use a 255.255.255.252 ip address with our ISP on the outside interface, this means I need to contact them and request a 255.255.255.248 address, correct?

1 REPLY

Re: PIX Failover configuration?

Correct.

When a failover does occurs, the 2 PIX's will swap addresses and mac addresses on each interface to ensure a seamless failover.

Scott

90
Views
0
Helpful
1
Replies
CreatePlease to create content