Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX FAILOVER

It's possible to configure pix 515e like a MHSRP ?

One virtual address for inside network and one virtual ip address for outside interface.

Thanks.

2 REPLIES
New Member

Re: PIX FAILOVER

The inside and outside interfaces will be in two different subnets/networks. So MHSRP is not applicable here. Yes if PIX supports HSRP, it should be possible to configure the way you have specified.

New Member

Re: PIX FAILOVER

If you have two pix firewall's you would configure failover. It works a lot like HSRP, but uses only two addresses instead of three. Configure the IP address on the primary active pix. In the config, another command will state "failover ip address". This sets the ip address of the standby pix. When a failover occurs, the two devices swap ip address The standby becomes active, and starts using the ip addresses defined in the config for the "active" pix.

85
Views
0
Helpful
2
Replies
CreatePlease to create content