09-25-2002 06:08 AM - edited 02-20-2020 10:16 PM
It's possible to configure pix 515e like a MHSRP ?
One virtual address for inside network and one virtual ip address for outside interface.
Thanks.
10-01-2002 08:55 AM
The inside and outside interfaces will be in two different subnets/networks. So MHSRP is not applicable here. Yes if PIX supports HSRP, it should be possible to configure the way you have specified.
10-18-2002 12:57 PM
If you have two pix firewall's you would configure failover. It works a lot like HSRP, but uses only two addresses instead of three. Configure the IP address on the primary active pix. In the config, another command will state "failover ip address". This sets the ip address of the standby pix. When a failover occurs, the two devices swap ip address The standby becomes active, and starts using the ip addresses defined in the config for the "active" pix.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: