Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix failover

On Pix Version 5.3(1). Can you configure the PIX to failover back to the Active after the Standby has become active and the fault on the original active has been fixed.

1 REPLY
Anonymous
N/A

Re: pix failover

The simple answer is no. The secondary PIX will stay active until it develops a fault such as losses a link, powers off, reboots or if you type the no fail over active command on the active pix or if you type fail over active on the standby pix.

84
Views
0
Helpful
1
Replies