Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Pix firewall 506 - static (inside outside) problem

Hello,

i am connected the server behand the firewall..

firewall ip address -outside - 64.170.x.1 inside -192.168.1.1

IIS server A -ip address inside -192.168.1.2 outside - 64.170.x.2

above server working fine and also i have

IIS server B ip address -64.170.x.3 which is not behand firewall.and also its working fine. now i shifted this server behand the firewall

i given inside 192.168.1.3 outside 64.170.x.3 - now from out side we cannot access the server all configuration is same as above server.

is it happening b'cause of before this ip address is outside the firewall?

i clear the arp also but not working.any help

Thanks

Sunil Kolkur

2 REPLIES
New Member

Re: Pix firewall 506 - static (inside outside) problem

Did you change the default gateway of your IIS server B to point to the firewall's internal interface ?

Ben

New Member

Re: Pix firewall 506 - static (inside outside) problem

yes i did change the default gateway of iis server B,same problem

server cannot access outside firewall...and from outside we cannot access that server..any help

100
Views
0
Helpful
2
Replies
CreatePlease to create content