Pix Firewall Config changes

[nojpt]

Hi,

I am going to change the Ip address, interface name and security number, access-group name on the interface and take out the ospf routing on that interface on our pix firewall.

My question is, in doing these changes, will the interface i will be working on go down and hence the box will failover to the standby box?

Thanks in advance.

[m.sir]

I think its failover to the standby

According this document

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008017278a.html#wp1051278

Ping test is performed every 5 seconds - so Interface IP address change cause failover...

M.