On a PIX 525 running ver 6.3 with a 4 port 10/100 card installed will it be possible to configure the interfaces as follows:
e0 - Inside interface
e1 - Firewall stateful failover
e2 - Firewall Failover monitoring link
e5 - Outside interface
I am basically unsure as to whether is is possible to move the outside interface from it's default configuration as e0 to e5 and similarly if it will be possible to specify e0 as the inside interface instead of the default confiuration of e1=inside.
One other quickie - I assume that with the additional 4 port 10/100 card installed my interfaces will be numbered e0-e5. Is that correct?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...