I just installed PIX 501E, configured vpn hardware client connect to UK's C3XXX concentrator. But inside Lan can not ping remote Lan. I used the software client is OK. May I know what is difference between Hardware client & software client. When software client connected, remote concentrator will push out their internal ip addr into software client, we can use the internal ip addr communication with centre. How about hardware client!
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...