Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX Interface Errors After SW Upgrade

Recently upgraded a pair of PIX-515's (not E's) from 5.x to 6.2, and am now seeing lots of errors on the inside Ethernet interfaces. They pass traffic, but the errors are numerous enough that there's clearly something wrong.

Tried speed/duplex, cable swaps, etc., to no avail. I found some old field notices about Ethernet controller errors on older 515's, but these weren't on the affected list.

Ideas?

  • Other Security Subjects
1 REPLY
New Member

Re: PIX Interface Errors After SW Upgrade

OK...a dope slap on this one... Turns out the speed/duplex settings on the PIX's were fine. Only trouble is nobody ever did anything with the settings on the switch they were connected to (I know, it's a software upgrade...why would you have to?). But, a quick flip to auto-negotiate on the switch to get things settled down, and everything is good again. Ugh!

89
Views
0
Helpful
1
Replies
This widget could not be displayed.