Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix Interface Problem

I have to PIXen running PIX Code 6.1(1). The secondary PIX is showing an interface in Normal (Waiting) mode. Now I have replaced the PIX and 4-port Ethernet card (PIX-525 team running 6.1(1) code.

At this point, I am swapping the failover cable and possibly upgrading the software. Does anyone know of a software bug that may cause this?

Many thanx.

1 REPLY
Cisco Employee

Re: Pix Interface Problem

I doubt this'll be hardware related, I've seen interfaces get "stuck" quite often. First off I would seriously consider upgrading to 6.1(4) at least, 6.1(1) is not a good code to run, lots of issues with it. You cna also try a "failover reset" command to see if that'll bring the interfaces up into the proper mode.

In short, stop replacing hardware, I doubt that's the problem.

183
Views
0
Helpful
1
Replies
CreatePlease to create content