Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

PIX Lab setup

Hi...

I have apix 515 FW with DES enabled. I want to set it up to test VPN. I have a 2950 at hand and I was wondering if the right setup is to connect the pix outside interface to a pc with vpn client and the inside to the switch where another host is connected, then try to access this host using the vpn client.

I just want to make sure this is the right way before starting the setup.

Thanks...

1 REPLY
Community Member

Re: PIX Lab setup

yes mate that would work fine, although you could just put the inside pc directly to the pix as well and bypass the layer 2 switch...

206
Views
0
Helpful
1
Replies
CreatePlease to create content