Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX nat 0 outbound connection

I have servers behind my pix that need to initiate outbound connections and allow certain inbound connections. I have tried Nat 0 but I can never initiate an outbound connection, haven't gotten far enough to try inbound.

current setup

gateway 64.124.139.1 255.255.255.192

outside 64.124.139.62 255.255.255.192

inside 192.168.1.1 255.255.255.0

nat (inside) 0 0

static (inside, outside) 64.124.139.14 64.124.139.14

I need this to work for several different internal addresses.

When I use

global (outside) 1 64.124.139.55

nat (inside) 1 0.0.0.0 0.0.0.0

it works but of course it is translating

I have been searching all day, any help is much appreciated

1 REPLY
Cisco Employee

Re: PIX nat 0 outbound connection

I do not understand why you want to use nat 0 when you inside addresses are private addresses (192.168.1.1).

The second way you did it is the correct way to perform inside to outside connection.

In any case, I think what you have been wanting to do is just make the 192.168.1.1 have a static translation.

You need a public ip address for this.

You should have been doing :

static(inside,outside) 64.124.139.14 192.168.1.1

Please look here for more explanations:

http://www.cisco.com/warp/customer/707/28.html

236
Views
0
Helpful
1
Replies
CreatePlease to create content