Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

PIX, NAT and PPPoE

I am trying to configure a PIX 506E for home office use on ADSL. The provider requires PPPoE and dynamic addressing. I am able to do everything I need except create a translation to allow smtp inbound (I have a mail server inside). I just cannot figure out how to do a static translation to a dynamic address. I'm sure it's supported but I cannot figure out how.

1 REPLY
Silver

Re: PIX, NAT and PPPoE

static (inside,outside) tcp interface smtp inside.host.ip.address smtp netmask 255.255.255.255 0 0

97
Views
0
Helpful
1
Replies
CreatePlease to create content