This is a lame question, so i apologize in advance.
On network diagrams, when using the Cisco supplied PIX stencil, is there a 'right' way to face the stencil. I mean, should the arrow be facing in the outbound direction, with the vertical line closer to the 'outside' interface?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...