Configuration Replication is NOT performed from Standby unit to Active unit. Configurations are no longer synchronized."
happens when you log into secondary PIX and enter commands.
Error Message %PIX|ASA-1-709006: (Primary) End Configuration Replication (STB)
Explanation This is a failover message. This message is displayed when the standby unit completes replicating a configuration sent by the active unit. (Primary) can also be listed as (Secondary) for the secondary unit.
I was worried because i have 2 pix firewalls and 1 is always tripping off( ie the network interfaces just stop responding) When it happens, i do a reboot and its back up. could u tell me what the problem is and possible solutions. I am considering an upgrade of the ios.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...