Use a Tacacs Server and enable aaa accounting for your needed reports. You can get accounting reports based on inbound and outbound IP addresses. If you want to get reports based on usernames, you must also authenticate the users against your tacacs server.
A simple solution to collect info on all traffic that traverse the PIX is to configure the pix to dump its log into a syslog server. We use syslog on a solaris server and set the debug level to 7 on the PIX. Expect a lot of data though. If you use Windows, I am sure you can find syslog for windows. You get verything: source ip/port destination ip/port and where applicable, full URL info. And it is all timestamped, of course.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...