Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

PIX setup with a single IP

What this stems from is the ISP does not want to give me multiple IP's. Setup is a ADSL connection acting as a bridge connected to a PIX 501 version 6.2.

The outside interface has a public IP address. Then you have to have another public IP for the global address. Or do you? The internal private addresses have to be NAT'ed to a public address, why can it not be the outside inferface address instead of another public IP.

1 REPLY
Community Member

Re: PIX setup with a single IP

You can NAT all private addresses to the public outside interface address of the PIX, by using the following command line:

global (outside) 1 interface

I hope this is what you were looking for.

98
Views
0
Helpful
1
Replies
CreatePlease to create content