I accidentally posted this question in the incorrect forum earlier today. I could not find a way to move it or delete it, so I apologize for the duplication.
I have established a site to site VPN between 2 Pix 506e's. I setup the VPN tunnle using the VPN wizard, and it appears to work properly. â¨
â¨However, I also have users who VPN directly into the PIX via PPTP or a Cisco VPN client. Those users are not able to access resources that are on the other end of the VPN tunnel. It appears as though the map ACL that triggers packets to be sent across the tunnel is not being matched, but I have not been able to figure out how to get this to work properly. â¨
PIX A has a local subnet of 192.168.1.x/24. PIX B has a local subnet of 192.168.2.x/24. Traffic between these 2 subnets flow across the tunnel. However, when someone establishes a VPN into PIX B, they are also put into the 192.168.2.x/24 subnet, but they are unable to access anything in the 192.168.1.x/24 subnet. Is something like this possible? The config from PIX B is attached. â¨â¨Any help you could offer would be greatly appreciated.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...