Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX software

Hi

I am going to upgrade my PIX(520)software version from 6.2 to 6.3(3).But I want take backup of existing version 6.2

copy flash tftp--This command does not exist.

Is there any way to copy existing software for backup ??

Please help me.

Ishwar

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: PIX software

Hi Ishwar,

Please send e-mail to scott (cisco) also, please read the following post (posted recently):

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.eea04c4

Thanks - Jay

4 REPLIES
New Member

Re: PIX software

I would assume you are downloading the update? I believe Cisco lets you download the previous versions too. Also the version that is installed is normally shipped with the PIX on CD.

Check out:

http://www.cisco.com/cgi-bin/tablebuild.pl/pix

For the list of images.

New Member

Re: PIX software

HI

Unfortunately, I do not have any right to download it.

I Just want to know that how can I take backup from PIX itself.Because I have to revert back to old version if any problem occure.

Ishwar

Re: PIX software

You cannot pull the current image off of the PIX. Send me an e-mail (sclayton@cisco.com) with a current 'sh ver' from the PIX and I will post the code for you in case you need to revert back after the upgrade.

Scott

Gold

Re: PIX software

Hi Ishwar,

Please send e-mail to scott (cisco) also, please read the following post (posted recently):

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.eea04c4

Thanks - Jay

190
Views
5
Helpful
4
Replies
CreatePlease to create content