Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX Stateful VPN Failover

Hi!

I just installed a PIX Failover.

Failover is working except w/ VPN. VPN client can connect to the active PIX device whether Primary or Secondary is the active one. Problem is when a Failover occurs and a VPN client is connected, the traffic is not passed through. I had to reconnect the VPN Client.

I was under the impression that VPN Stateful failover will enable the VPN client to continue working even when a Failover occurs.

I'm running PIX v 7.2(2) on both PIX.

PIX UR license on Primary

PIX FO license on Secondary

FO link & Stateful failover link shares the same port - eth 0.

question - is there an additional command to enable VPN stateful failover.

i followed this link as a guide to configure the FO

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Thanks!

1 REPLY
Anonymous
N/A

Re: PIX Stateful VPN Failover

117
Views
0
Helpful
1
Replies