Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pix static map using PAT address

I have an ISP that will only give out one ip address per MAC address. I am using PAT for outbound traffic but need to add a static mapping for incomming SMTP traffic. The static map command will not let you use an address in the PAT pool. Any ideas on a work around?

1 REPLY
New Member

Re: Pix static map using PAT address

You can use the same IP for both the Static translation and MX entry (for SMTP traffic). We have implemented a number of projects where this is being done and it just works fine.

Regards / Sampath

sampathsr@samw.com

105
Views
0
Helpful
1
Replies