At what point does the PIX issue the 'connection built' syslog message. Example - 04 04 12:42:38 DMZPIX %PIX-6-302013: Built outbound TCP connection -668712345 for outside:xxx.xxx.xxx.xxx/1234 (xxx.xxx.xxx.xxx/1234) to inside:xxx.xxx.xxx.xxx/4514 (xxx.xxx.xxx.xxx/4514)
Is this done only after a completed TCP handshake or after an intial SYN (is this when PIX builds connection slot?)or some other citeria?
Explanation A TCP connection slot between two hosts was created.
connection number is a unique identifier.
interface, real_address, real_port identify the actual sockets.
mapped_address, mapped_port identify the mapped sockets.
user is the AAA name of the user.
If inbound is specified, then the original control connection was initiated from the outside. For example, for FTP, all data transfer channels are inbound if the original control channel is inbound. If outbound is specified, then the original control connection was initiated from the inside.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...