Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

pix-to-conc

after connecting multiple remote-sites (pix) with a lan-to-lan-tunnel on a conc3000 - is it possible to communicate between the remote-sites via the conc?

regards

stefan

1 REPLY
Cisco Employee

Re: pix-to-conc

Yes, you just need to add each remote 501 network into the access-list on the other 501's and create network lists on the 3000 and define those as the local network for each L2L tunnel. If each 501 remote network is in the same major network (subnets of 10.0.0.0/8 for example), then you can just say "tunnel everything from my local network to the entire 10.0.0.0/8 network" on each PIX, and do a similar thing on the head-end 3000, makes life a lot easier.

91
Views
5
Helpful
1
Replies
CreatePlease to create content