Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Pix to Pix and VPN Client network - Need DMZ access from client

We have a Pix to Pix and VPN client config set up.

Pix A - HQ

Pix B - Branch

VPN client config programmed for Pix B. Pix B has DMZ interface. Currently the VPN client can access the inside network of Pix B. I need to allow the VPN client to access the DMZ. Can someone point me in the right direction? Thanks!

1 REPLY
Cisco Employee

Re: Pix to Pix and VPN Client network - Need DMZ access from cli

In PIX-B you'll have something like:

> nat (inside) 0 access-list 100

> access-list 100 permit ip

Add the following:

> nat (dmz) 0 access-list 101

> access-list 101 permit ip

and you should be good to go.

86
Views
0
Helpful
1
Replies
CreatePlease to create content