I would like to use PIX 501s in a partially meshed hub and spoke topology but I have a requirement for the spokes to communicate with each other. According to a TAC tech tip this isn't possible without a fully meshed topo. I already have a router at the hub site. Can this router be used to route the traffic between the spokes?
As long as your hub is a ROUTER, then it is possible, you cannot have PIX as the HUB, since PIX does not route traffic arriving on an interface out to same interface.
HTH
R/Yusuf
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: