Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX to PIX hub & spoke configuration

I would like to use PIX 501s in a partially meshed hub and spoke topology but I have a requirement for the spokes to communicate with each other. According to a TAC tech tip this isn't possible without a fully meshed topo. I already have a router at the hub site. Can this router be used to route the traffic between the spokes?

1 REPLY
Cisco Employee

Re: PIX to PIX hub & spoke configuration

As long as your hub is a ROUTER, then it is possible, you cannot have PIX as the HUB, since PIX does not route traffic arriving on an interface out to same interface.

HTH

R/Yusuf

108
Views
0
Helpful
1
Replies