Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX to PIX RAS VPN

Hi all,

I?m trying to connect to a remote site that is protected by a PIX 501 using the cisco vpn client. I can connect to the remote site if I go through a dialup or any other dsl connection, however, I cannot connect from our main office which is also protected by a PIX 506e. The PIX 506e is also configured for RAS VPN.

Cisco VPN Client (v4.x)--->PIX506--->Cisco827AdslRtr-->INTERNET<---Destination PIX501<--LAN

When I view the syslog from the pix 506e which is protecting my connection, I?m getting the following message ?%PIX-3-305006: portmap translation creation failed for protocol 50 src inside 172.16.1.132 dst outside:66.6.x.x?

Any assistance is appreciated

Don

  • Other Security Subjects
1 REPLY

Re: PIX to PIX RAS VPN

try adding the fixup protocol esp-ike this however will aloow only one connection at a time. Otherwise I suggest you using the PIX506e as VPN client to the 501 PIX. In that way you don't need to connect using the cisco VPN client installed on the user's PC.

I hope it helps .. please rate if it does !!

85
Views
0
Helpful
1
Replies
This widget could not be displayed.