06-25-2002 08:07 AM - edited 02-21-2020 11:49 AM
Hello ,
I had a question about the following setup.
10.10.10.x----PIX1----router------router-----PIX2------10.10.10.x
In the the above setup is it possible to set up a VPN tunnel between the two PIXs .If so can you please tell me how.Is there any documentation in the cisco site that says the VPN tunnel between two lans with same subets.
I know how I can do with diff subnets.
Please advise.
06-25-2002 06:45 PM
This will not work. Since the remote subnet is the same as the local subnet, the traffic for the remote network would not be forwarded through the tunnel, as it is supposed to be local.
Here is a tip in CCO in case there is a really desperate need for such a situation, but is only recommended as a temporary measure. You would then require two routers on either pixes inside to do some sort of natting for the identical subnets.
http://www.cisco.com/warp/customer/707/same-ip.html
Regards
06-26-2002 05:37 AM
Hello,
I have found a document on cisco site for the PIX.
http://www.cisco.com/warp/customer/707/vpn_pix_private.html.
I think we can do if we change the IP of the LAN using static statements.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: