Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIx to Pix VPN using DHCP

I have been looking at this document "http://www.cisco.com/warp/public/110/dynamicpix.html".

It suggests that you can setup a VPN connection that is initiated from one end only due to not knowing one of the ip addresses.

I have gone through the config and on the remote pix the external interface is setup for dhcp. Then Nat and the default route point to 204 net. How can this work if the interface is un-numbered?

===================================================

!

ip address outside dhcp

!

global (outside) 1 204.1.1.10-204.1.1.15

!

route outside 0.0.0.0 0.0.0.0 204.1.1.2 1

1 REPLY
Bronze

Re: PIx to Pix VPN using DHCP

I think it probably should look something like this..

ip address outside dhcp setroute

!

global (outside) 1 interface

!

nat (inside) 0 access-list 101

93
Views
0
Helpful
1
Replies
CreatePlease to create content