01-16-2008 02:26 PM - edited 02-21-2020 03:29 PM
I have a PIX-to-VPNConcentrator IPSEC tunnel.
I have a local host on my PIX inside interface with IP 192.168.5.5 but the site on the VPNConcentrator end of the tunnel wants to see IP 192.168.77.9 (because they're using the 192.168.5.x network at their end for some other use)
I know how to NAT stuff going from inside to outside, but I've never NAT-ed tunnel traffic before.
Can I NAT a local inside IP address BEFORE the traffic hits the tunnel?
Solved! Go to Solution.
01-16-2008 03:55 PM
Yes, this is possible. Please refer the below URL for configuration details:
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml
Regards,
Arul
01-16-2008 03:55 PM
Yes, this is possible. Please refer the below URL for configuration details:
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml
Regards,
Arul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: