Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX to VPN Concentrator tunnel, can I NAT traffic before the tunnel?

I have a PIX-to-VPNConcentrator IPSEC tunnel.

I have a local host on my PIX inside interface with IP 192.168.5.5 but the site on the VPNConcentrator end of the tunnel wants to see IP 192.168.77.9 (because they're using the 192.168.5.x network at their end for some other use)

I know how to NAT stuff going from inside to outside, but I've never NAT-ed tunnel traffic before.

Can I NAT a local inside IP address BEFORE the traffic hits the tunnel?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PIX to VPN Concentrator tunnel, can I NAT traffic before the

Yes, this is possible. Please refer the below URL for configuration details:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml

Regards,

Arul

1 REPLY
Cisco Employee

Re: PIX to VPN Concentrator tunnel, can I NAT traffic before the

Yes, this is possible. Please refer the below URL for configuration details:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml

Regards,

Arul

109
Views
0
Helpful
1
Replies