Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix upgrade from version 7.01 to version 7.02

HI,

i am planning an pix (2 nodes in failover) in transparent mode, multiple context from version 7.01 to version 7.02 but i have not find any doc for this type of upgrade. the available doc is from 6.3 to version 7.

Here is few issues that i need to address.

Will i need to go in monitor mode to perform this upgrade since it is a minor upgrade.

Would i loose my configuration after the upgrade, and what is the upgrade path, active node first, second after???

any link to a doc will be appreciated.

Thanks for your owns imputs.

Ralph

1 REPLY
Silver

Re: Pix upgrade from version 7.01 to version 7.02

I think you the previous confoguration will not be lost.

The steps given in the pix upgrade from 6.3 to 7 will be enough for upgrading 7.01 to 7.02.

For more information refer to following url:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_release_note09186a0080546bbd.html

101
Views
0
Helpful
1
Replies
CreatePlease to create content