Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX ver 6.3(3)109 and ip verify reverse-path

Anybody here know if the "ip verify reverse-path" commands are enabled by default for this release? I just noticed these were on when I upgraded the OS.

TIA

- Jericho

1 REPLY
Silver

Re: PIX ver 6.3(3)109 and ip verify reverse-path

This command is disabled by default. You can get more information about this command from the link below.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a9.html#1053009

Steve

94
Views
0
Helpful
1
Replies
CreatePlease login to create content