Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pix VPN access through NAT

I understand that the Altiga supports a VPN to

be established through NAT'd interfaces. I have

a scenario where I need to establish a VPN to a PIX

with a public interface by going through a router

that has NAT activated (overloaded).

Is this supported? Can I get this to work with

the PIX?

2 REPLIES
New Member

Re: Pix VPN access through NAT

I heard NAT transparency is on the roadmap for the PIX but I wouldn’t expect to see it anytime soon. Right now the 3000 and 5000 series are the only Cisco products I know of that offer this feature.

New Member

Re: Pix VPN access through NAT

I think your best bet is to try it out, use transport mode (not tunnel), it should be OK as you've only got one host (the PIX) behind the NAT'ing router.

92
Views
0
Helpful
2
Replies