12-08-2005 01:38 PM - edited 02-21-2020 02:08 PM
Hello,
I'm connecting to a PIX515 using the Cisco VPN client. The client connects, assigns me an IP address, DNS servers, etc, but I cannot access anything on the internal network.
I am initiating the connection from a remote site that is also behind a PIX515 doing PAT.
Any ideas welcomed. Config is attached for reference.
Thanks,
= K
12-08-2005 02:20 PM
try applying the command "isakmp nat-traversal 20".
also, verify whether the host 172.20.29.1 has a valid route for the vpn client pool subnet.
12-08-2005 03:13 PM
Thank you very much.
Adding the nat-traversal command solved the problem.
= K
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: