cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
355
Views
0
Helpful
2
Replies

PIX VPN with windows 2000 client

chris
Level 1
Level 1

I used to have my firewall setup so that windows 2000 clients could VPN into it and it was working fine. I recently configured the Firewall so that it would connect to another PIX firewall in a PIX-to-PIX configuration. That part of it is working fine, but for some reason my windows 2000 clients, once connected, cannot ping any hosts on the network. When I remove this command from the PIX the Windows 2000 client can then ping through.

crypto map transam interface outside

(After this is removed windows clients can ping through).

My access lists look fine and when I check them it shows that they are being hit.

Any help with this would be much appreciated.

Thanks,

Chris Neeser

P.S. I used http://www.cisco.com/warp/public/110/38.html to configure the PIX-PIX VPN and http://www.cisco.com/warp/public/110/pptppix.html to configure for the Windows 2000 clients

2 Replies 2

j-block
Level 4
Level 4

I'd suggest having a TAC engineer look over your config.

david_prakken
Level 1
Level 1

Is the ICMP leaving the PIX and not getting back? If so, make sure you have a route to your VPN IP Pool. It's a little hard to tell without seeing the config.

Dave

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: