Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX VPN with windows 2000 client

I used to have my firewall setup so that windows 2000 clients could VPN into it and it was working fine. I recently configured the Firewall so that it would connect to another PIX firewall in a PIX-to-PIX configuration. That part of it is working fine, but for some reason my windows 2000 clients, once connected, cannot ping any hosts on the network. When I remove this command from the PIX the Windows 2000 client can then ping through.

crypto map transam interface outside

(After this is removed windows clients can ping through).

My access lists look fine and when I check them it shows that they are being hit.

Any help with this would be much appreciated.

Thanks,

Chris Neeser

P.S. I used http://www.cisco.com/warp/public/110/38.html to configure the PIX-PIX VPN and http://www.cisco.com/warp/public/110/pptppix.html to configure for the Windows 2000 clients

2 REPLIES
New Member

Re: PIX VPN with windows 2000 client

I'd suggest having a TAC engineer look over your config.

New Member

Re: PIX VPN with windows 2000 client

Is the ICMP leaving the PIX and not getting back? If so, make sure you have a route to your VPN IP Pool. It's a little hard to tell without seeing the config.

Dave

83
Views
0
Helpful
2
Replies
CreatePlease login to create content