Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX Xauth authenticating to W2K IAS Radius Server

Has anyone had any luck getting this working? I followed the guidelines at http://www.cisco.com/warp/public/110/pixcryaaa52.html

but when I am prompted for the radius user/pass it fails. I checked the event logs and there's 2 entries... one that says successfully granted access, and then another at the same time saying that the username or password is wrong. I tried just using Radius authentication without IPSec, and it works. Anyone know what may be the problem?

3 REPLIES
New Member

Re: PIX Xauth authenticating to W2K IAS Radius Server

I believe your password must be the same on both sides. Do you have different usernames and passwords?

New Member

Re: PIX Xauth authenticating to W2K IAS Radius Server

I have the exact same problem on a 515 running 5.2(5). The TAC has no resolution and suggested that I upgrade to 5.3(1). What version are you using?

New Member

Re: PIX Xauth authenticating to W2K IAS Radius Server

I'm using 5.3(1). I got it working actually. Just had to reset the IAS server. Go figure, MS products.

116
Views
0
Helpful
3
Replies