Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX

Hello,

I am encountering the following error message "%PIX-6-110001: No route to dest_address from source_address" on my corporate PIX firewall. I am very sure that there is a route in the routing table. In other words, it is just routing between 2 different interfaces on the PIX firewall from higher to lower security i.e. dest_address is having lower security than the source_address.

Please advice what can I do next? Thanks.

3 REPLIES
New Member

Re: PIX

do you have a nat translation for these interfaces?

ex. static (inside,dmz)

then you will need an acl to support as well.

New Member

Re: PIX

Thanks froggy3132000.

I have the following nat translation command:

nat (inside) 0 0.0.0.0

nat (outside) 0 0.0.0.0

nat (dmz) 0 0.0.0.0

Is it necessary to configure the static command?

From what I understand, static command allows traffic to originate from an interface with a lower security to an interface with a higher security.

Please advice. Thanks.

New Member

Re: PIX

Please post your config.

And let us know exactly what traffic is not being routed correctly.

101
Views
0
Helpful
3
Replies
CreatePlease to create content