Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

PIX501 - PDM - Unsupported Command Found

Hi,

I am using a PIX501 with PDM 3.0(4) and PIX OS 6.3(5) and I cant use PDM to make configurations.

When a try open Configuration tab in PDM a message "Unsupported Command Found"

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: PIX501 - PDM - Unsupported Command Found

Do you have "nat (interface access-list" commands in the PIX?

If you do PDM will not wor with them as the error says.

Try to change the nat with acl as a nat with a subnet and then PDM is going to work.

I hope it helps.

PK

1 REPLY
Cisco Employee

Re: PIX501 - PDM - Unsupported Command Found

Do you have "nat (interface access-list" commands in the PIX?

If you do PDM will not wor with them as the error says.

Try to change the nat with acl as a nat with a subnet and then PDM is going to work.

I hope it helps.

PK

420
Views
0
Helpful
1
Replies
CreatePlease to create content